Step 17. Adjust Decorative Panels - GE ZISS480DRHSS Installation Instructions Manual

Installation Instructions
[STEP 17 ADJUST DECORATIVE PANELS - FLUSH INSTALLATION ONLY
Each door panel can be adjusted approximately 1/8"
both left and right, up and down, as well as outward
from the door to provide planar appearance with
cabinets.
NOTICE: Misaligned door panels from incorrect drilling
or incorrect cut dimensioning may result in less possible
adjustment as well as possible interferences with other
attached panels and/or hardware,
1, The gap between the outside edge of the door panels
and the cabinet opening should be 9/16", Adjust panels
until specified gap is maintained,
_--9/16" _--9/16"
Door panels and hood panel should be
flush with the fronts of the cabinets.
,
Check that the fresh food and freezer door panels are
in plane with the face of the cabinets, The panel can be
adjusted outward by turning the set screw threaded into
the tab of the door bracket at the top and bottom of the
door clockwise until the face of the panel is in the same
plane as the cabinetry,
,
_)_ a _ _ _., ,, ,, %r_
IHJ
flush with cabinetry,
IPlF
Check the flushness of the panel with the cabinetry,
If the grille is not flush, adjustments can be made by
loosening the screws in the slots on the hinge and
moving the panel in or out, Once all adjustments are
made, retighten screws and close the grille,
,
Turn the set screw at the hinge side (top and bottom)
of the refrigerator clockwise to adjust the door panel
toward the edge of the door opening, Check the gap by
closing the door,
Turn set screw on
hinge side, top and
bottom, clockwise
to move toward the
door opening,
Use these screws
to adjust the grille
panel in or out-
both sides,
24