Table of Contents
Advertisement
STEP 10A INSTALL OVERLAY PANELS
Use Rear Holes
to Secure Trim
Install door and drawer panels:
• Open door to 90°. Remove the 4 Phillips head screws
from the door handle.
• Remove handle. Retain all screws.
• Remove 4 screws holding trim, lift off trim.
Retain screws.
• Slide overlay panel into the door trim.
Custom handles
If you are using custom handles, the handle must be
properly secured to the panel before sliding the panel
into the trim.
• The cabinet manufacturer will supply the custom
handle and hardware.
• Secure the door/drawer trim using both the FRONT
and REAR screw holes. Discard supplied handle.
Installation Instructions
Handle
Trim
Move
Forward
For 3/4"
Panel
Use Front Holes
to Secure Handle
Supplied handle shown in the
Right hand models shown. Use the same instructions
for left hand models.
Door Trim
Refrigerator
Door
overlay panel position.
• There are two sets of holes in the handle side trim.
Replace handle side trim by installing the original screws
in the REAR screw holes.
• Secure the handle to the door using the FRONT
screw holes.
• Follow the same procedures to install the drawer panel.
15
Advertisement
Table of Contents
