Table of Contents
Advertisement
Available languages
Available languages
Installation Instructions
El
PREPARING THE OPENING (Continuedl
9/16"
min.
fiat
_
I
P
1/4" min. flat
23-3/16"
1-
29-15/16"-
30-1/16"
smooth
cut
25"
typically
9/16"
min. ]
X:a:_!
The Standard
Installation
of this Drop-In Range is to hang
by the countertop
on the side metal flanges under glass
cooktop. This Range must not be installed
on a base or
sub structure
12"× 4" support).
If the construction
of your cabinet cannot provide a
1/4" flat area at the back of the countertop
opening,
consider changing
the countertop
to accommodate
this
dimension.
If the area is not flat, excess tension may
be applied to the glass cooktop, causing breakage and
voiding the warranty.
Flat
area
R
_'/'A
(-
Countertop
Range support
Countertop
thickness
1-1/4" min. is required to support the product. Braces must be installed between the
underside
of the countertop
and the cabinet if required to obtain 1-1/4" minimum
thickness (each side).
Hake sure the wall coverings, counters
and cabinets around the oven can withstand
the heat (up to 200 ° F
(93.3 ° C) generated
by the oven.
This appliance has been approved for 0" spacing to adjacent surfaces above the cooktop. However, a 6"
minimum spacing to surfaces less than 15" above the cooktop and adjacent cabinet is recommended to
reduce exposure to steam, grease splatter and heat.
Locate the wiring junction
box at the rear of the cutout. The dimension
from the top of the wiring junction
box to the countertop
must be a minimum
of 28-1/2". The box must not extend more than 3" off the plane
of the wall. The junction
box must be located where it will allow considerable
slack in the range conduit, so
that the range can be pulled out for service if necessary.
3
Advertisement
Table of Contents
