Advertisement
BURNER
STYLE #3 (TWIN BURNER)
CONVERSION
INSTRUCTIONS
Two Piece Burner Cap
I
Remove Burner Mounting Screws
Unlike the standard
gas range, THIS COOKTOP
IS NOT REMOVABLE.
Do not attempt
to remove this cooktop.
For all burner locations:
a. Remove burner grates & lift off the two piece burner cap. (Fig. 15)
Fig. 17
!
Simmer
Orifice
_win
Orifices
!
_Orifice
Openings
]
b. Remove the two burner mounting screws using the appropriate
screwdriver or nutdriver and remove burner head (Figs 16). NOTE - Burners may be
secured with 3/16" hex head screws or square drive screws,
c. Remove the factory installed natural gas orifices from the orifice holders using a 7 mm nutdriver (See Fig 17). Save the natural gas orifices
removed
from the appliance
for possible
future conversion
back to natural
gas.
d. Replace the orifice in each of the orifice holders with the appropriate
LP/Propane gas orifice from the envelope
labeled SCREW
MOUNTED
BURNER
LP KIT. Note that there are two identical orifices for the main portion of the burner and a separate smaller orifice for the center/simmer
portion of the burner. Tighten all orifices until snug. Use CAUTION
not to overtighten.
e. Replace burners at all locations and tighten each position with original screws. Burners MUST have a Burner Cap installed to insure proper ignition
and gas flame size.
GAS SURFACE
BURNER ORIFICE DATA CHART (Burner
Style #3)
SIMMER
TWIN (Main)
BTU Rating / Natural Gas
750
17,000
Natural Gas Orifice
0.43
1.46
(Qty 2)
L P Gas Orifice
0.22
0.84 (Qty 2)
LP Orifice Marking Color
Orange
Purple
BTU Rating / LP Gas
750
15,000
*Note: For operation
at elevations
above 2000 ft., appliance
rating
shall
be reduced
at the rate of 4 percent
for
each 1000 ft. above sea level.
BURNER
STYLE #3 (TWIN BURNER)
CONTROL
VALVE ADJUSTMENT
Adjust
the "LOW"
Setting
of the Twin Burner
Surface
Valve
Fig.
t8
(Figure
18) (some
models):
Note: On the Twin burner surface valve the low setting of each portion
(inner portion and outer portion of the twin burner) should be adjusted
individually.
_'_
a. Push in and turn control to ignite the burner
,_
b. Quickly turn knob to LOWEST POSITION.
c. If burner goes out, reset control to OFF.
d. Remove the surface burner control knob.
e. The inner portion of the twin burner flame size can be increased or
decreased with the turn of the screwA. Use screw B to adjust the
flame size of the outer portion of the twin burner. Turn
counterclockwise
the screw to increase flame size. Turn clockwise the
screw to decrease flame size. Adjust flame until you can quickly turn
knob from LITE to LOWEST POSITION without extinguishing the
flame. Flame should be as small as possible without going out.
Note: Air mixture adjustment is not required on surface burners.
Advertisement
