Table of Contents
Advertisement
Quick Links
30" GAS RANGE INSTALLATION INSTRUCTIONS
INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER.
IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE.
READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
If the information in this manual is not followed
exactly, a fire or explosion may result causing property
damage, personal injury or death.
FOR YOUR SAFETY:
— Do not store or use gasoline or other flammable vapors
and liquids in the vicinity of this or any other appliance.
— WHAT TO DO IF YOU SMELL GAS:
• Do not try to light any appliance.
• Do not touch any electrical switch; do not use any phone
in your building.
• Immediately call your gas supplier from a neighbor's
phone. Follow the gas supplier's instructions.
• If you cannot reach your gas supplier, call the fire
department.
— Installation and service must be performed by a qualified
installer, service agency or the gas supplier.
Clearances and Dimensions
1. Location—Check location where the range will be
installed. Check for proper electrical and gas supply,
and the stability of the floor.
2. Dimensions that are shown must be used. Given
dimensions provide minimum clearance. Contact
surface must be solid and level.
p/n 316469109 EN/FR (1002)
(For gas venturi models with electric ignition)
1
Refer to your serial plate for
applicable agency certification
Note: For appliances installed in the
Commonwealth of Massachusetts see
page 2.
Provide Proper Fuel Type
Before Proceeding: Your appliance was preset at the
factory to operate on Natural Gas.
Please note: For operation at elevations above 2000 ft.
(610m), appliance rating shall be reduced at the rate of 4
percent for each 1000 ft. (305m) above sea level.
DO NOT attempt to convert this range to
L.P. (Propane) without the proper L.P. (Propane)
conversion kit provided with this appliance or obtained from
your dealer. Follow all instructions provided with the
conversion kit.
Français - pages 9-16
Advertisement
Table of Contents
Related Manuals for Crosley CRG3150PW
Summary of Contents for Crosley CRG3150PW
- Page 1 30" GAS RANGE INSTALLATION INSTRUCTIONS (For gas venturi models with electric ignition) INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER. IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE. READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE. If the information in this manual is not followed exactly, a fire or explosion may result causing property damage, personal injury or death.
-
Page 2: Important Safety Instructions
30" GAS RANGE INSTALLATION INSTRUCTIONS (For gas venturi models with electric ignition) Important Notes to the Installer Never leave children alone or unattended 1. Read all instructions contained in these installation in the area where an appliance is in use. As children grow, instructions before installing range. -
Page 3: Before Starting
30" GAS RANGE INSTALLATION INSTRUCTIONS (For gas venturi models with electric ignition) A. Locate the Bracket Using the Template - (Bracket may Before Starting be located on either the left or right side of the range. Use Tools You Will Need the information below to locate the bracket if template is For leveling legs and Anti-Tip Bracket: not available). -
Page 4: Provide An Adequate Gas Supply
30" GAS RANGE INSTALLATION INSTRUCTIONS (For gas venturi models with electric ignition) Connect the range to the gas supply. C. Level and Position Range - Level range by adjusting the NOTE: To prevent leaks use pipe joint sealant on all male (4) leveling legs with a wrench. - Page 5 30" GAS RANGE INSTALLATION INSTRUCTIONS (For gas venturi models with electric ignition) the 1/2" flare union adapter with an adjustable wrench before tightening the gas supply fitting and/or appliance conduit (Refer to Fig. 4e). d) Install flare union adapter to external manual shut-off valve. e) Attach appliance conduit to flare union on shut-off valve.
- Page 6 30" GAS RANGE INSTALLATION INSTRUCTIONS (For gas venturi models with electric ignition) Grounding Instructions 5. Read these electrical connection details first then connect electricity to range. The power cord of this appliance is equipped with a Before servicing, disconnect electrical 3-prong (grounding) plug which mates with a standard supply at circuit breaker, fuse or power cord.
- Page 7 30" GAS RANGE INSTALLATION INSTRUCTIONS (For gas venturi models with electric ignition) Operation of Surface Burners B u r n e r Operation of electric igniters should be checked after range and Baffle 1" Flame supply line connectors have been carefully checked for leaks and range has been connected to electric power.
- Page 8 30" GAS RANGE INSTALLATION INSTRUCTIONS (For gas venturi models with electric ignition) Model and Serial Number Location When ordering parts for or making inquires about your range, always be sure to include the model and serial numbers and a lot number or letter from the serial plate on your range.