Attaching The Work Bowl - KitchenAid 5KFP1335 Instructions Manual

Attaching the Work Bowl
I. Place the Food Processor on a dry,
level countertop with the controls
facing forward. Do not plug in the Food
Processor until it is completely assembled.
2. Place the work bowl on the base, aligning
the raised portion with the indentation on
the base. The center hole should fit over
the power shaft.
Attaching the Work
Bowl Cover
NOTE: Be sure t0 install the desired
accessory before attaching the work
bowl cover.
I. Place the work bowl cover on the work
bowl with the feed tube just to the left
of the work bowl handle. Grasp the feed
tube and turn the cover to the right until
it locks into place.
3. Grasp the work
bowl handle and turn
the bowl counterclockwise to lock it
on the base.
2. Fit the food pusher into the 3-in- I
feed tube. See "Using the 3-in- I Feed
Tube" for details on working with
different sized foods.
NOTE: Your Food Pr0cess0r witt not
operate unless the work bowl and work
bowl Cover are properly locked on the
base, and the large pusher is inserted to
the maximum fill line on the feed tube
(approximately halfway down).
Select the accessory you would like to use
and install it according to the instructions on
the following pages.
12