Assembling The Food Processor; Attaching The Work Bowl; Attaching The Work Bowl Cover - KitchenAid 5KFP0933AAC Instructions Manual

ASSEMBLING THE FOOD PROCESSOR

Attaching the work bowl

Before First Use
Before using your Food Processor for the
first time, wash all parts and accessories
either by hand or in the dishwasher (see
"Cleaning the Food Processor" section).
NOTE: Your Food Processor is shipped
with the work bowl cover installed on
the work bowl.
IMPORTANT: Place the Food Processor
on a dry, level countertop with the
controls facing forward. Do not plug
in the Food Processor until it is
completely assembled.
Place the work bowl on the base,
2
aligning the raised portion with the
indentation on the base. The center
hole should fit over the power shaft.

Attaching the work bowl cover

NOTE: Be sure to install the desired accessory before attaching the work bowl cover.
Place the work bowl cover on the work
1
bowl with the feed tube just to the left
of the work bowl handle. Grasp the feed
tube and turn the cover to the right until
it locks into place.
NOTE: Your Food Processor will not operate unless the work bowl and work bowl cover
are properly locked on the base, and the large pusher is inserted to the maximum fill line
on the feed tube (approximately halfway down).
Power Shaft
Grasp the feed tube on the work bowl
1
cover and turn it clockwise to remove
it from the work bowl.
Grasp the work bowl handle and turn
3
the bowl counterclockwise to lock it
on the base.
Fit the food pusher into the 3-in-1
2
feed tube. See "Using the 3-in-1 Feed
Tube" for details on working with
different sized foods.
7