Attaching The Seat; Tire Pressure - Craftsman T1000 Operator's Manual

F
\
Figure3
3.
Place the steeringwheel capoverthe centerof the steeringwheeland
pushdownwarduntil it "clicks"into place.
Attaching The Seat
If the seatforyourtractorwasnot attached at the factory,referto the following
steps.
NOTE: Forshippingreasons, seatsareeitherfastened to the tractorseat'spivot
bracket w ith a plastic tie, or mountedbackward to the pivotbracket. I neithercase,
freethe seatfrom its shipping positionandremove the adjustment k nobfrom the
bottomofseatbeforeproceeding with the instructions below.
1. Asalready instructed,remove the seatadjustmentknobinstalledbythe
factoryin the bottomofthe seat.See"a"in Figure 4.
®
Slidethe seatrearwardin the seatpivotbracket(c),liningup the center
rearslotinthe pivot bracket w ith the remainingholeinthe seat's base.See
Figure 5.
Note: Becertainthe two seattabsengauge the pivot bracket a sshownin
the bottominsetof Figure 5.
Figure 5
4. Selectdesired positionforthe seat,andsecure with the adjustment k nob
removed earlier(din Figure 5).
5. Toadjustthe positionof the seat,remove the adjustment k nobon the
bottomof the seat.Slidethe seatforwardor backward asdesired. R einstall
the adjustmentknob.SeeFigure 5.
Tire Pressure
Maximum tire pressure u nder anycircumstances is30 psi.Equal t ire pressure
shouldbe maintained at all times. Neverexceedthe maximum inflation
)ressure shown on the sidewallof the tire,
The recommended operating t irepressure is:
Approximately 10psi f ortherear tires
Approximately 14psi f orthefronttires
IMPORTANT: Referto the tire sidewallfor exacttire manufacturer's
recommended or maximumpsi. Donot overinflate.Uneventire
pressurecouldcausethe cuttingdeckto mowunevenly.
2.
Figure4
Alignthe seatoverthe seatpivotbracketasshownin Figure 4andfit the
seatontothe pivotbracketinsertingthe two tabsonthe seatbottominto
the slotsonthe pivotbracket.
10