Installation; Electrical - Kelvinator KCGM10RW Instructions Manual

Avoid fire hazard o_
e_ s k Do _:_ot _ ,,_s÷ a n on co_d
or an adapter pl:eg_ Do r_ot _emov÷ any
prong from the pow÷r cord
PROHIBTION
o:o Do not attempt to remove or repair any component
unless instructed by factory.
o_o Make sure that the unit is not resting on or against
the electrical cord and the plug.
o:o Do not store any flammable and explosive gas or
liquids inside the unit.
o:o Do not attempt to alter or tamper with the
electrical cord.
INSTALLATION
IMPORTANT!!! PLEASE READ BEFORE
INSTALLATION
o:o The refrigeration system operates most efficiently
when installed in an area with cool, dry air
circulation.
o:o There must be at least 6 inches of clearance on both
sides and the back of the cabinet.
o:o Select a location away from the heat and moisture
generating equipment such as stoves, ovens, etc.
°:° Avoid direct sun rays.
o:o Make sure all accessories are installed (i.e. shelves,
shelf clips, casters) before plugging the unit in.
o:o Please read through the manual in its entirety.
CABINET LOCATION GUIDELINES
o:o Install the unit on strong and leveled surfaces
• Unit may make unpleasant noises if surface is
uneven
• Unit may malfunction if surface is uneven
•:. Install the unit in an indoor, well-ventilated area
• Unit performs more efficiently in a well-
ventilated area
• For best performance, please maintain
clearance of 4" on the back of the unit.
• Outdoor use may cause decreased efficiency
and damage to the unit.
•:. Avoid installation in a high humidity and/or dusty
area
• Humidity could cause unit to rust and decrease
efficiency of the unit
• Dust collected on the condenser coil will cause
unit to malfunction. Clean the condenser at
least once a month with a brush or a clean
cloth.
o:o Select a location away from heat and moisture-
generating equipment
• High ambient temperatures will cause the
compressor to overwork, leading to higher
energy bills and gradual breakdown of the unit
ELECTRICAL
Please ensure that the required voltage of the
compressor is being supplied at all times. Low or high
voltage can detrimentally affect the refrigeration unit.
All units should be plugged into a grounded and
properly sized electrical outlet with appropriate
overcurrent protection. Please refer to the electrical
requirement on the nameplate. Please make sure that
your unit has its own dedicated outlet. Do not use an
extension cord.
The temperature controls are preset at the factory to
maintain an average temperature of 38 F in
refrigerators. To maintain a different temperature,
simply adjust the control knob located inside the unit.