Installation - Kelvinator KIL320BFWD User Manual

INSTALLATION

Location
When selecting a position for your Fridge/Freezer you should make sure the floor is flat and firm,
and the room is well ventilated with an average room temperature of between 16℃ and 32℃.
Avoid locating your Fridge/Freezer near a heat source, eg, cooker, boiler or radiator. Also avoid
direct sunlight in out-buildings or sun lounges. If you are placing your Fridge/Freezer in an
out-building such as a garage or annex ensure that the Fridge/Freezer is placed above the damp
course, otherwise condensation will occur on the Fridge/Freezer cabinet. Never place the
Fridge/Freezer in a wall recessed or into fitted cabinets or fumiture when your Fridge/Freezer is
working, the grille at the back may become hot and the sides warm. It must therefore be installed
so that the back of the Fridge/Freezer has at least 9cm(31/2") of free space and the sides have
2cm(3/4"). Do not drape the Fridge/Freezer with any covering.
Leveling the Fridge/Freezer
If the Fridge/Freezer is not level, the door and magnetic seal alignment will be affected and may
cause you Fridge/Freezer to work incorrectly. Once the Fridge/Freezer is placed in its final
location, adjust the leveling feet at the front by turning them.
Install outside handle
a.Remove the screws from the left side of door with a screwdriver,
b.fix the handle with screws on the left side of door by screwdriver
and then put the screw cap on the screws.Put away the plastic hole
cover for future demand .
3