Makita 1051D Instruction Manual page 15

To install the blades, first clean out all chips
I
or
foreign matter adhering to the drum or
blades. Insert the blade between the drum
cover
from
the side opposite the belt so
that the blade end will protrude slightly
from the side of the drum. Tighten the two
installation bolts securely with the hex
wrench provided.
Drum cover
1
lnstalation bolts
Planer blade
Side of drum
Drum
CAUTION:
Use only the Makita hex wrench provided to remove or install the blades. Failure to do so
may result in overtightening or insufficient tightening of the installation bolts. This could
cause an injury.
Hex wrench storage
When not in use, the hex wrench can be
conveniently stored.
15