Makita 1051D Instruction Manual page 12

Edge fence (Guide rule)
Use the edge fence when shiplapping (rab-
beting) or cutting workpieces nearly
50
mm
(1-31/32") wide. Install the edge fence on
the tool and secure it with the washer and
thumb screw (A). .Loosen the thumb screw
(B) and adjust the edge fence until
it
comes
in contact with the side of the workpiece.
Then tighten the thumb screw (B) securely.
-
Edge fence - I
---
-
Thumb screw
(e)
-
I
/ -
------
c
/
E -
Blade height adjustment
Blade height adjustment is usually not nec-
essary. However, if you notice that the
blade edge is below the level of the rear
base or protrudes too far from the rear
base, proceed as follows.
Loosen the two installation bolts. Turn the
pan head screws clockwise to retract the
blade or counterclockwise to protrude it.
After adjusting the blade height, tighten the
two installation bolts securely.
Pan head screws
- , ,
Installation bolts
I
I
12