Makita 1051D Instruction Manual page 11

Adjusting depth of cut
The depth
of
cut can be adjusted in 0.1 mm increments within a range
of 0
-
0.5
mm
(0.02").
Turn the knob on the front of the tool until the pointer
is
aligned with the desired
cutting depth on the scale.
Scale
1
Pointer
CAUTION:
The knob can be turned beyond the 0.5 mm (0.02") graduation. However, do not operate
the tool with a depth of cut more than 0.5 mm (0.02"). The motor may be burned out or
the battery cartridge may be damaged.
Switch
action
CAUTION:
Before inserting the battery cartridge into the tool, always check to see that the switch
trigger actuates properly and returns to the "OFF" position when released.
To
prevent the switch trigger from being
accidentally pulled, a lock-off button is pro-
vided. To start the tool, depress the lock-off
11