Remove the internal USB connector.
7.
To replace the component, reverse the removal procedure.
Integrated power supply rear cover
To remove the component:
Power down the server (on page 28).
1.
Remove the power from the server:
2.
Disconnect the power cord from the power source.
a.
Disconnect the power cord from the server.
b.
Do one of the following:
3.
Extend the server from the rack (on page 29).
o
Remove the server from the rack (on page 30).
o
Remove the access panel
4.
("Access
panel" on page 35).
Removal and replacement procedures 60