Connecting The Strobe - Sea&Sea MDX-RX100/? Instruction Manual

Connecting the Strobe

Connect the strobe with the fiber-optic cable (option) when the strobe is
triggered by sensing the light from the camera's built-in flash.
1
Remove the fiber-optic cable
socket caps
2
Insert the fiber-optic cable's
connector into the socket until
it stops
Do not remove the caps from
fiber-optic cable sockets not in use
to keep light from entering in.
CAUTION
Before inserting the fiber-optic cable, check to make sure that there are
no scraches or dirt on the connector surface. Scratches or dirt may
cause the strobe to malfunction.
To protect the surface from scratches or dirt, do not remove the caps from
the fiber-optic cable sockets when the cable is not inserted.
There is no possibility of water leaking from the fiber-optic cable socket
even if the fiber-optic cable/cable socket cap is removed underwater.
After the strobe is connected to the housing, make sure to check that the
connected strobe functions correctly before underwater use.
E-13
Fiber-optic cable socket cap