Connecting The Strobe - Sea&Sea MDX-7D Instruction Manual

Connecting the Strobe

This product comes equipped with a
strobe bulkhead (①) / a YS converter
bulkhead (②) and two fiber-optic cable
sockets.
When connecting the strobe with
the sync cord (option) / YS converter (option)
Connect the strobe with the sync cord (option) or YS converter (option)
when the strobe is triggered in conjunction with the camera.
CAUTION
Make sure never to connect the Strobe sync cord to the bulkhead for YS
converter (②). This may damage the pins on the bulkhead connector.
Likewise, make sure never to connect the YS converter's connecting cable
to the strobe bulkhead (①). This may damage the pins on the bulkhead
connector.
Carefully observe the instruction manual for the sync cord / YS converter
before use.
with the sync cord
1
Remove the housing's bulkhead connector cap
2
Make sure there are no scratches
or debris on the O-ring of the sync
cord being connected
3
Align the round mark (or the notch
on the tip) of the sync cord with
the round mark (or the convex
part inside) of the strobe bulkhead,
and then push it straight in
fiber-optic cable socket
Sync cord
Strobe bulkhead
②
①
E-20