spring will fall out. Take care not
to lose the compression spring.
[ECA12912]
1
2
1. Bolt
2. Oil filter element cover
6. Remove and replace the oil filter
element and O-rings.
PERIODIC MAINTENANCE AND ADJUSTMENT
2
1
3
4
1. Oil filter element cover
2. O-ring
3. Compression spring
4. Oil filter element
7. Install the compression spring and
oil filter element cover by installing
the bolts, then tightening them to
the specified torque.
Tightening torque:
Oil filter element cover bolt:
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
TIP
Make sure that the O-rings are properly
seated.
8. Install the engine oil drain bolt and
its new gasket, and then tighten
the bolt to the specified torque.
6-14
Tightening torque:
Engine oil drain bolt:
20 Nm (2.0 m·kgf, 14 ft·lbf)
9. Refill with the specified amount of
the recommended engine oil, and
then install and tighten the oil filler
cap.
Recommended engine oil:
See page 8-1.
Oil quantity:
Without oil filter element replace-
ment:
1.50 L (1.59 US qt, 1.32 Imp.qt)
With oil filter element replacement:
1.70 L (1.80 US qt, 1.50 Imp.qt)
TIP
Be sure to wipe off spilled oil on any
parts after the engine and exhaust sys-
tem have cooled down.
NOTICE
Do not use oils with a diesel
specification of "CD" or oils of a
higher quality than specified. In
6
ECA11671