Philips FC9910 User Manual page 36

English
36
Problem
The robot vacuum
cleaner gets louder
and louder.
Error indications
E0
E1
E2
E3
E4
E5
E6
E7
Possible cause
You started cleaning
in auto cleaning mode
from another place in
the room than the base
station.
You cleaned a small area
in spot cleaning mode.
When the robot vacuum
cleaner has cleaned the
area, it automatically
stops.
The dust container is
full and/or the filters are
dirty.
The roller brush is dirty.
Cause Solution
Rechargeable Charge the robot vacuum cleaner.
battery is empty
Wheel lifted The robot vacuum cleaner is stuck on a threshold or another
height difference. Move it to a flat area.
Floor detection Move the robot vacuum cleaner to a flat area.
error
Dust container The dust container is not properly inserted. Insert the dust
error container properly (see chapter 'Cleaning and maintenance').
Wheel motor Check if there is any dirt (hair, fluff etc.) attached to
overload the wheels. Remove the dirt (see chapter 'Cleaning and
maintenance').
Brush motor Check if there is any dirt (hair, fluff etc.) attached to the roller
overload brush or side brush. Remove the dirt (see chapter 'Cleaning
and maintenance').
Vacuum cleaner Clean the filters and empty the dust container (see chapter
motor overload 'Cleaning and maintenance').
Inner system error Set the on/off switch to OFF and then set it to ON again.
Solution
When you start cleaning in auto cleaning mode from
another place in the room than the base station,
the robot vacuum cleaner returns to this place after
cleaning. To ensure the robot vacuum cleaner returns
to the base station, place the base station in the room
where you want to use the robot vacuum cleaner and
start cleaning from the base station.
This is normal in the spot cleaning mode. You can
press the base button on the remote control to make
the robot vacuum cleaner return to the base station
or you can press the mode button to switch to auto
cleaning mode. In auto cleaning mode, the robot
vacuum cleaner automatically returns to the base
station, provided it is placed in the same room.
Empty and clean the dust container and clean the
filters (see chapter 'Cleaning and maintenance').
Clean the roller brush (see chapter 'Cleaning and
maintenance').