Philips FC9910 User Manual page 35

Problem Possible cause
The robot vacuum You forgot to set the on/
cleaner does not off switch on the bottom
respond. of the robot vacuum
cleaner to ON.
The rechargeable battery
of the robot vacuum
cleaner is empty.
The rechargeable battery
is not placed in the robot
vacuum cleaner correctly.
The non-rechargeable
batteries of the remote
control are empty.
The infrared signal
generator and/or infrared
signal emitter is covered
or dirty.
The remote control is
too close to the base
station.
The robot vacuum The base station or the
cleaner does not robot vacuum cleaner is
charge. not properly connected
to the mains.
The robot vacuum The base station is not
cleaner does not properly connected to
return to the the mains.
base station after
cleaning.
The infrared signal
generator or emitter of
the base station or one
or more sensors of the
robot vacuum cleaner
are covered.
The base station is
located behind a wall
or other obstacle that
blocks the signal.
Solution
Set the on/off switch to ON and then press the power
button on the robot vacuum cleaner.
Recharge the robot vacuum cleaner.
Remove the rechargeable battery from the robot
vacuum cleaner and reinsert it.
Replace the batteries of the remote control with non-
rechargeable batteries of the same type.
Make sure nothing covers the infrared signal generator
and/or infrared signal emitter or blocks its signal.When
the infrared signal generator and/or infrared signal
emitter is dirty, clean it with a soft clean cloth.
Move further away from the base station and then
operate the remote control again while pointing it in
the direction of the base station.
Make sure you insert the small plug properly into the
socket on the base station or robot vacuum cleaner.
Also make sure that you insert the small plug of the
mains cord properly into the adapter and that you
insert the mains plug properly into the wall socket.
Make sure you insert the small plug properly into the
socket on the base station or robot vacuum cleaner.
Also make sure that you insert the small plug of the
mains cord properly into the adapter and that you
insert the mains plug properly into the wall socket.
Remove the object that covers the infrared signal
generator or emitter of the base station or one or
more sensors of robot vacuum cleaner.
Put the base station in a different place. Make sure
there are no obstacles within 0.5m on both sides of
the base station or within 1.5m in front of the base
station. To ensure the robot vacuum cleaner returns
automatically to the base station after cleaning, the
base station must be placed in the same room as
where the robot vacuum cleaner is cleaning.
English
35