1.
Select Start > All Programs > Intel > Intel Rapid Storage Technology.
2.
Click the Acceleration link, and then click the Disable Acceleration link.
3.
Wait for the Acceleration Mode to complete.
4.
Click the Reset to Available link.
IMPORTANT:
enable SRT. Failure to temporarily disable this feature will prevent you from creating or changing RAID
volumes.
NOTE:
HP does not support SRT with self-encrypting drives (SEDs).
Removing or replacing the service door
Removing the service door
Remove the service door to access the memory module slot, hard drive, and other components.
1.
Remove the battery (see
2.
With the battery bay toward you, slide the service door release latch (1) to the left, remove the screw (if
the optional screw is being used) (2), and then slide the release latch again (3) to release the service
door.
NOTE:
You must temporarily disable SRT when changing RAID modes. Make the change and then re-
Removing a battery on page
If you do not want to use the optional screw, you can store it inside the service door.
46).
Using hard drives
57