Removing Back Plate - Lennox ComfortSense 7500 Installation And Setup Manual

S
Not close to entrance or automatic
doors
S
Not close to heat generating
equipment such as kitchen equipment
S
Not in an enclose environment unless
a remote indoor sensor is used.
S
Hot or cold air from ducts.
S
Radiant heat from sun or appliances.
S
Concealed pipes and chimneys.
S
Unheated (uncooled) areas such as
an outside wall behind the thermostat.
Figure 2. Removing Back Plate
4. Use steps A through J (step J applicable
when using provided wall plate) to install the
thermostat.
CUT OR DRILL A SMALL HOLE
FOR THERMOSTAT WIRING
A
¾" x ¾"
PULL ABOUT 3" OF THERMOSTAT
WIRE THROUGH OPENING AND RE­
MOVE OUTER THERMOSTAT WIRE
JACKET.
THIS WILL HELP IN
ROUTING THE THER­
MOSTAT WIRING TO
THE PROPER THER­
MOSTAT TERMINALS
7
B