Energy Saving Default; System Test Modes; Energy Saving Set Points - Lennox ComfortSense 7500 Installation And Setup Manual

NOTE - Humidification and dehumidifica­
tion are not part of the energy savings pro­
gram. A higher utility bill may occur when
not using the setpoints in this table.

ENERGY SAVING DEFAULT

Energy saving recommended set points for
heating and cooling can help save energy. The
time and temperatures reference in table 2 are
pre-programmed into the thermostat to achieve
energy savings.
Scroll to ENERGY SAVING DEFAULT; press to
select. Read the message on the screen and to
continue, press CONFIRM.
Table 2. Energy Saving Set Points
Time
Wake
Leave
Return
Sleep

SYSTEM TEST MODES

After the thermostat has been installed and set-up,
the installer may run a system test function
(accessed through the installer settings menu), to
test all cooling, heating, emergency heating
stages and FAN outputs.
Select system test mode. A pop-up will be
displayed indicating all equipment will be stopped.
Press confirm to continue.
Pressing the OFF button next to the desired option
will change the status to ON and will enable the
relay for that terminal. Pressing again will turn OFF
the relay. Press the left arrow (<) to exit the system
test mode.
35
Heating
70°F (21°C)
62°F (17°C)
70°F (21C)
62°F (17°C)
Cooling
78°F (25°C)
85°F (29°C)
78°F (25°C)
82°F (28°C)