Progr Amming Your Coffeemaker; Auto Brew Del Ay - Black & Decker CM2030B User Manual

PROGR A M M I NG YO UR CO FFE E M AKE R
SETTING THE DIGITAL CLOCK
1. Plug your coffeemaker into a standard electrical outlet.
2. The digital clock will flash "12:00" to indicate that the time has not
yet been set.
3. Press the HOUR button until the correct hour appears on the display.
A "PM" symbol will appear in the upper right hand corner of the digital
display to indicate afternoon time settings. This symbol will not appear
for AM settings.
4. Press the MIN (minute) button until the correct minute value appears on
the display.
5. Your clock is now set.
SETTING THE AUTO BREW DELAY START
1. Ensure the digital clock has been set (see "SETTING THE DIGITAL CLOCK"
section for assistance).
2. Press the PROG (program) button. The display will flash "12:00."
3. Press the HOUR and MIN buttons until they indicate the time you would like
automatic brewing to begin.
A "PM" symbol will appear in the upper right hand corner of the digital
display to indicate afternoon time settings. This symbol will not appear
for AM settings.
4. The Auto Brew display will flash for a few moments before switching back to
the digital clock.
TIP: After programming, press the PROG button to check the preset Auto Brew time.
ACTIVATING THE AUTO BREW DELAY
1. Ensure the Auto Brew delay time has been set (see "SETTING THE AUTO BREW
DELAY" section for assistance).
2. Press the AUTO button once. The timer icon (
Brew has been activated.
3. If Auto Brew is activated, be sure to have both coffee grounds and water in your
coffeemaker. When the time of day and programmed Auto Brew time match, your
coffeemaker will automatically brew a fresh pot of coffee.
4. To deactivate Auto Brew, press the AUTO button again. The timer icon (
will disappear.
Note: If the unit is unplugged or power is interrupted, the digital clock and
Auto Brew settings will need to be reprogrammed.
) will appear, indicating that Auto
8
)