Dyna-Glo DGA550SSN User Manual page 9

ASSEMBLY INSTRUCTIONS
4. Attach the cart left and right side panels (D & E)
by placing the panel keyholes over the screw
heads (AA) on the bottom shelf (A). Slide the
cart side panels (D & E) so that the screw head
is over the smaller part of the keyhole. Thread
the screws (AA) down snug but DO NOT tighten
as some slack will be necessary in following
assembly steps.
5. Partially insert two M6x12 screws (AA) into the
cart left and right side panels (D & E).
Hardware Used
AA
M6x12 Screw
6. Attach the cart rear panel (F) by sliding the keyholes
in the cart rear panel (F) over the inserted screws
(AA). Slide the cart rear panel (F) down to meet
bottom shelf (A). Secure the cart rear panel (F) to
the bottom shelf (A) with three M6x12 screws (AA).
Tighten all screws, including the two screws in cart
side panels (D & E).
Hardware Used
AA
M6x12 Screw
4
1
A
5
x 2
6
D
2
x 3
9
D
AA
1
1
1
D
AA
1
1
F
1
A
E
AA
2
2
2
E
E
1