Table of Contents
Advertisement
30
external network. This ports available differ depending on the access point model deployed. Access
point models with a single port have this option fixed.
• Enable NAT on the WAN Interface - Select the checkbox to allow traffic to pass between the access
point's WAN and LAN interfaces.
16. Select Next. The Initial AP Setup Wizard displays the Radio Configuration screen to define support for
the 2.4GHz radio band, 5GHz radio band or to set the radio's functionality as a dedicated sensor.
NOTE
17. Set the following parameters for the radio:
• Configure as a Date Radio - Select this option to dedicate this radio for WLAN client support in either
the selected 2.4 or 5GHz radio band.
• Radio Frequency Band - Select either the 2.4GHz or 5.0GHz radio band to use with the radio when
selected as a Data Radio. The selected band is used for WLAN client support. Considers selecting
one radio for 2.4GHz and another for 5GHz support when supporting clients in both the 802.11bg
and 802.11n bands.
• Power Level - Use the spinner control to select a 1 - 23 dBm minimum power level to assign to this
radio in selected 2.4 or 5.0 GHz band. 1 dBm is the default setting.
• Channel Mode - Select either Random, Best or Static. Select Random for use with a 802.11an
radio. To comply with Dynamic Frequency Selection (DFS) requirements in the European Union, the
802.11an radio uses a randomly selected channel each time the access point is powered on.
The ADSP Sensor Support field displays at the bottom of the screen
only if a radio has been dedicated as a sensor.
AP-8132 Access Point
Hide quick links:
Advertisement
Table of Contents
