Motorola AP-8132 Installation Manual page 13

Installation Guide
c. Connect the power supply line cord to the power adapter.
d. Attach the power adapter cable into the power connector on the access point.
e. Attach the power supply line cord to a power supply.
CAUTION
5. Verify the unit has power by observing the LEDs. For more information on AP-8132 LED behavior, see
Indicators on page 19
6. Align the bottom of the ceiling T-bar with the back of the access point.
7. Orient the access point chassis by its length and the length of the ceiling T-bar.
8. Rotate the access point chassis 45 degrees clockwise.
9. Push the back of the access point chassis on to the bottom of the ceiling T-bar.
10. Rotate the access point chassis 45 degrees counter-clockwise. The clips click as they fasten to the T-bar.
11. The access point is ready to configure.
If not using an AP-PSBIAS-2P3-ATR model power injector, ensure only
the AP-8132's designated power supply (PWRS-14000-247R) is used
to supply power to the access point. Using an incorrectly rated power
supply could damage the access point and void the product warranty.
Do not actually connect to the power source until the cabling portion
of the installation is complete.
.
13
LED