Table of Contents
Advertisement
42
Resources Controlled By Auto [Auto(ESCD)]
You should leave this item at the default Auto (ESCD). Under this setting, the system dynamically
allocates resources to Plug and Play devices as they are required.
If you cannot get a legacy ISA (Industry Standard Architecture) expansion card to work properly,
you might be able to solve the problem by changing this item to Manual, and then opening up the
IRQ Resources submenu.
•
IRQ Resources [Press Enter]
IRQ to Legacy ISA, then that Interrupt Request Line is reserved for a legacy ISA
expansion card. Press <Esc> to close the IRQ Resources submenu.
PCI/VGA Palette Snoop [Disabled]
This item is designed to overcome problems that can be caused by some non-standard VGA cards.
This board includes a built-in VGA system that does not require palette snooping so you must leave
this item disabled.
Assign IRQ For USB [Enabled]
Names the interrupt request (IRQ) line assigned to the USB on your system. Activity of the
selected IRQ always awakens the system.
PC Health Status
On motherboards that support hardware monitoring, this item lets you monitor the
parameters for critical voltages, temperatures and fan speeds.
Shutdown Temperature
CPU Vcore
Vcc
Vcc
Voltage Battery
Current System Temp
Current CPU Temp
CPUFAN1 Speed
CASFAN1 Speed
Shutdown Temperature [Disabled]
Enables you to set the maximum temperature the system can reach before powering down.
System Component Characteristics
These fields provide you with information about the systems current operating status. You cannot
make changes to these fields.
:In the IRQ Resources submenu, if you assign an
Phoenix-AwardBIOS CMOS Setup Utility
PC Health Status
[Disabled]
3.3V
5.0V
+12V
: Move Enter: Select +/-/PU/PD:Value F10:Save ESC:Exit F1: General Help
F5:Previous Values
F6:Fail-Safe Defaults
Using BIOS
Item Help
Menu Level
F7:Optimized Defaults
Advertisement
Table of Contents
