Table of Contents
Advertisement
40
lets you install a software power down that is controlled by the power button on your system. If the
item is set to Instant-Off, then the power button causes a software power down. If the item is set to
Delay 4 Sec. then you have to hold the power button down for four seconds to cause a software
power down.
Power On After Power Fail (Off)
This item enables your computer to automatically restart or return to its last operating.
AMD K8 Cool'n'Quiet control (Auto)
This item helps the system to lower the frequency when CPU idles. When the frequency decreases,
the temperature will drop automatically as well.
IRQ/Event Activity Detect (Press Enter)
Scroll to this item and press <Enter> to view the following screen:
X
X
VGA (Off)
When set to On, the system power will resume the system from a power saving mode if there is
any VGA activity.
LPT & COM (LPT/COM )
When this item is enabled, the system will restart the power-saving timeout counters when any
activity is detected on the serial ports, or the parallel port.
HDD & FDD (ON)
When this item is enabled, the system will restart the power-saving timeout counters when any
activity is detected on the hard disk drive or the floppy diskette drive.
PCI Master (OFF)
When set to Off, any PCI device set as the Master will not power on the system.
PowerOn by PCI Card (Enabled)
Use this item to enable PCI activity to wakeup the system from a power saving mode.
Modem Ring Resume (Disabled)
Use this item to enable modem activity to wakeup the system from a power saving mode.
RTC Alarm Resume (Disabled)
When set to Enabled, additional fields become available and you can set the date (day of the
month), hour, minute and second to turn on your system. When set to 0 (zero) for the day of the
month, the alarm will power on your system every day at the specified time.
Press <Esc> to return to the Integrated Peripherals page.
Phoenix-AwardBIOS CMOS Setup Utility
IRQ/Event Activity Detect
VGA
[OFF]
LPT & COM
[LPT/COM]
HDD & FDD
[ON]
PCI Master
[OFF]
PowerOn by PCI Card
[Enabled]
Modem Ring Resume
[Disabled]
RTC Alarm Resume
[Disabled]
Date (of Month)
0
Resume Time (hh: mm: ss)
0 : 0 : 0
IRQs Activity Monitoring
[Press Enter]
: Move Enter: Select +/-/PU/PD:Value F10:Save ESC:Exit F1: General Help
F5:Previous Values
F6:Fail-Safe Defaults
Using BIOS
Item Help
Menu Level
When Select Password,
Please press ENTER
key to change Password
Max 8 numbers.
F7:Optimized Defaults
Advertisement
Table of Contents
