ADJ PAR Z4 User Instruction page 7

Par Z4
3. Press ENTER to confirm your desired set up.
DIND -
This will let select your desired dimmer curve.
1. Press the MENU button until "DIND" is displayed, and press
ENTER. 1 of 5 dimmer curves will be displayed. "STDA" (stan-
dard), "STGE" (stage), "TV" (TV), "ARAL" (Architectural), or
"THAL" (Theatre). See the dimmer curve chart on page 22 for
more info.
2. Press the UP or DOWN buttons to find your desired dimmer
curve and press ENTER to confim and exit
LED -
With this function you can have the display back-
light turn off after 10 seconds.
1. Press the MENU button until "LED" is displayed, press
ENTER.
2. The display will show either "ON" or "OFF". Press the UP or
DOWN buttons to select "ON" to keep the LED display on at
all times, or "OFF" to switch to have the LED display switch off
after 10 seconds.
3. Press ENTER to confirm. To make you LED display reappear
again press any button.
DISP -
This function will reverse the display 180º.
1. Press the either the MENU button until "DISP" is displayed,
press ENTER.
2. Press the UP button to select "DSIP" to "flip" the display, or
"DISP" to revert the display to normal.
3. Press ENTER to confirm.
ADJ Products, LLC - www.adj.com - Par Z4 Instruction Manual Page 12
System Menu
.
Par Z4
BALA
- With this function you can adjust the RGB colors
to balance out the white color.
1. Press the MENU button until "BALA" is displayed, press
ENTER.
2. Use the UP or DOWN buttons to find the color you wish to
adjust.
3. Once you find the color you want to adjust press ENTER, the
displayed value will begin to flash. Use the UP or DOWN but-
tons to adjust the value. Once you have made your adjustment
press ENTER.
4. Repeat steps 2-3 until satisfied.
MANU
- This function will allow you to manually adjust
each LED output intensity, dimmer intensity, and strobe
rate. This function is also a manual testing mode.
1. Press the MENU button until "MANU" is displayed, press
ENTER.
2. Use the UP and DOWN buttons to scroll through the vari-
ous LED colors, master dimmer, and storbe setting. Once you
have found your desired function you would like to adjust press
ENTER.
3. After you have pressed ENTER, use the UP and DOWN but-
tons to adjust the values. Once you have adjusted the output
intensity of each color and the master dimmer, and set your
desired strobe setting do not exit this function. Your settings
will remain until you press the MENU button to exit.
TEST
- This function will run a self test program.
1. Press the MENU button until "TEST" is displayed, press
ENTER.
ADJ Products, LLC - www.adj.com - Par Z4 Instruction Manual Page 13
System Menu