Top Flue Exit; Rear Flue Exit - Stanley Oisin Installation And Operating Instructions Manual

Where a masonry chimney is not available a propri-
etary type of 5"/6" - 12.5/15cm twin wall, fully insu-
lated pipe may be used. The pipe must terminate at
a point not lower than the main ridge of adjacent out-
side obstructions. With such installation, access to
the chimney must be provided for cleaning purpos-
es. (See Fig.1)
Flue Liner
Stainless Steel
chimney
connector
Insulated
non-combustible
throat seal
When flue piping passes through closure plate with
sliding door, ensure that the pipe continues up and
is ultimately connected to the flue liner and well
sealed with fire cement.

TOP FLUE EXIT

For the top outlet configuration, remove the blank-
ing plate (part no.10) from the hob, remove the flue
spigot (part no.11) from the back plate and fix it to
the hob. Fix the outlet blanking plate to back plate
(see Fig. 2). Push the flue outlet connector pipe (not
supplied) into the flue spigot and cement into place
using approved fire cement ensuring that no cement
blocks the flue passageway.
Fig.2
Fig.1

REAR FLUE EXIT

Push the flue connector pipe (not supplied) into the
flue spigot and cement into place using approved
fire cement ensuring that no cement blocks the flue
passageway (see Fig.3).
Fig.3
Fig.4
4