Optional Rear Vent Shield; Bottom Heat Shield - Harman Oakwood Wood Stove Owner's Manual

Oakwood Woodburning Stove
D. Optional Rear Shield
The rear heat shield,(Top Vent #1-00-02492 - Rear Vent #1-
00-02493), will allow you to install your Oakwood closer to
the wall. Please note there are two different shields based
on whether the unit is rear or top vented.
Rear Vent
3-90-08327
Top Vent
Harman® • Oakwood Owner's Manual_R34 • 2004 -___ • 09/15
E. Bottom Heat Shield
Part #1-00-797058 recommended to be installed whenever
the Oakwood is installed on a protected combustible floor.
The shield installs on four bolts that are located on the side
of the base of the stove body. Slide the shield under the
stove from the back. Lift into place and install bolts through
the holes in the shield.
F. Optional Cozy Screen
This appliance has been tested and approved for burning as
an open fireplace. To do so, a spark screen (Harman part#
3-40-06960; Cozy Screen) must be installed over the front
door opening. The by-pass damper must be kept in the open
position.
The Cozy Screen can be used from the start of a fire or can
be used with an existing one. When starting a fire with the
Cozy Screen, smoke spillage may occur until it develops a
draft strong enough to pull all smoke back into the flue.
DO NOT LEAVE THE APPLIANCE UNATTENDED WITH
THE DOOR OPEN!
Load only small amounts of wood at a time.
Slide heat shield in from
the rear of the unit
Dry Seasoned Wood Only! 25