Appliance Set-Up; Outside Air Attachment; Leveling The Appliance; Optional Cooking Grill - Harman Oakwood Wood Stove Owner's Manual

7

Appliance Set-Up

A. Outside Air Attachment
Parts and Supplies Needed from Local Hardware Stove: 1
piece of 4 in. (4.5 in. OD) aluminum flex dryer vent (4 in.
rigid aluminum duct is not a suitable substitute and will not
work) x needed length, 1 rodent screen, aluminum tape and
a trim ring for finished around the outside air pipe inside the
home.
1. Determine an appropriate hole location, through the
wall. Be sure there are no studs or other supporting
members. Also ensure there are no electrical wires or
plumbing contained within the wall.
2. Make the hole through the exterior wall using a hole
saw or reciprocating saw. You'll want the hole to be just
slightly larger than the metal flex pipe.
3. Attach the rodent screen to one end of the flex pipe,
and insert it through the wall until the back of the screen
cover is against the outside surface.
4. Hold the flex pipe in place to make an accurate
determination of the length needed. Cut the flex pipe
to length.
5. Slide the trim ring onto the flex for the inside wall portion.
6. Slide the other end of the metal intake flex pipe into
the stub on the rear of the Oakwood and secure it with
aluminum tape. This air intake will supply outside air for
the secondary combustion within the FireDome.
7. Secure the trim ring in place for finishing the inside wall
area.
8. Seal around the rodent screen on the exterior wall,
using silicone caulking.
!
NEVER DRAW OUTSIDE COMBUSTION AIR FROM:
• WALL, FLOOR OR CEILING CAVITY.
• ENCLOSED SPACE SUCH AS AN ATTIC OR GARAGE
24 Dry Seasoned Wood Only!
CAUTION
Outside Air
Attachment
Harman® • Oakwood Owner's Manual_R34 • 2004 -___ • 09/15
B. Leveling the Appliance
To adjust the leveling bolts, you must first loosen the locking
nut. Turn the leveling bolt to the desired position, and tighten
the locking nut against the cast iron leg.
C. Optional Cooking Grill
The optional cooking grill #1-00-08121 installs easily in the
top load opening of the Oakwood.
The grill handle (B) fits in the slots (C) on each side. To
remove the handle, lower and turn.
When installed, the grill hangs in the opening by the hooks
(A).
When grilling, you'll want to keep the fire size small and
the bypass damper in the open position. Depending on the
grilling being done, you may get grease dripping on the
glass causing it to become dirty and obstructed. When you
burn your next hot fire, the glass will likely clean itself.
A
C
Oakwood Woodburning Stove
B
A
3-90-08327
A
C