FELIXrobotics FELIX 3.0 User Manual page 24

b. Fill in these values here:
6. Press the OK button to save the new calibration values and print out the calibration part again to verify
calibration values give the desired result. The two squares located at 4,4 (highlighted in blue) should be
perfectly aligned on top of each other.
7. If this is successful, you are done with the calibration and you can now successfully print with your dual
head printer.
8. On our webpage a pre-sliced dual head print-file is available which will print a part of the accessories set
of the printer.
http://shop.felixprinters.com/downloads/print_files/accessoires/F3_0/print_assy_felix_F3_0_dual_extrud
er_accessory_V6.gcode
Currently there are two methods we support to print with dual extrusion. Kisslicer external program
and Slice3r, integrated program in repetier-host. See further chapters.
support@FELIXprinters.com
www.FELIXprinters.com
User manual FELIX 3.0 3d printer