Dual Head Printing - FELIXrobotics FELIX 3.0 User Manual

7 Dual head printing

This chapter describes how to calibrate your dual extrusion printer and describes additional steps to make a
dual extrusion print.
Assumed in the following steps is that repetier-host is already installed, that the hot-ends are calibrated
correctly to have the same height and that you just finished assembling your DIY kit.
1. Make sure you have the latest dual extrusion firmware loaded.
2. Prepare the repetier-host interface for dual extrusion.
3. Print test_thinwall_v3.gcode with extruder 1.
a. Go to repetier interface and select extruder 1. Heat up extruder and heated bed.
b. Printed output must show a smooth straight wall. Possible issues:
support@FELIXprinters.com
www.FELIXprinters.com
User manual FELIX 3.0 3d printer