Strymon DIG User Manual page 7

DIG
- Dual Digital Delay User Manual
Expression Input Modes
The EXP jack on your DIG is set up for Expression Pedal from the factory. To change the
Expression Input mode, hold down both TAP and BYPASS footswitches while powering up.
While holding down, move the toggle switches to one of the three positions shown below.
EXPRESSION PEDAL
Power up with both toggle switches
in the UP position while both
holding footswitches to configure
for use with an expression pedal.
Connect a standard TRS expression
pedal for control over any knob.
To assign the knob
controlled by the
expression pedal:
Power down your
pedal. Hold the TAP
footswitch during
power up, while
turning the knob
you'd like to assign.
The maximum
position the knob is
turned up to becomes
the expression pedal
"toe down" maximum
value.
FAVORITE SWITCH
Power up with both toggle switches
in the MIDDLE position while
holding both footswitches to
configure for use with a FAVORITE
switch. To save a favorite setting,
press and hold the Bypass switch.
HOLD BOTH AT POWER UP while changing toggle
switch position to set Expression Input Mode
EXTERNAL TAP
Power up with both toggle switches
in the DOWN position while holding
both footswitches to configure for
use with an external TAP switch.
®
pg 7