Strymon DIG User Manual page 4

DIG
- Dual Digital Delay User Manual
Dual Delay Config
The secondary function for the MIX 2 knob sets the Dual Delay configuration.
Press and hold both TAP and BYPASS footswitches while turning the MIX 2
knob to adjust. Turn left for Series, center for
configuration.
SERIES
In Series configuration, Delay 2
feeds Delay 1. This is equivalent
to putting two single delay pedals
in succession on your pedal
board. A mono input feeds both
left and right channels.
Ping Pong, or right for Parallel
PING PONG
In Ping Pong Mode, the delays
are configured in a series
'ping-pong' configuration. When
using a mono output signal, this
configuration is the same as the
Series configuration.
In stereo, each delay acts as
a ping-pong delay, and they
interact when both Mix knobs are
turned up.
PARALLEL
In Parallel configuration, the
delays do not interact with each
other, but produce their outputs
'side-by-side'.
In Stereo, Delay 1 outputs to the
left channel, and Delay 2 outputs
to the right channel. When the
right output is not used, the wet
signal sums to mono so that
both parallel delays are heard
from the left output.
®
pg 4