Strymon DIG User Manual page 10

DIG
- Dual Digital Delay User Manual
Circular Repeats
Holding down the TAP footswitch enables Circular
Repeats, where both delay lines maintain a static
volume and repeat continuously until the TAP
footswitch is disengaged. At this point, all previous
settings will be restored.
TRS Stereo Input
The 1/4" input can be set for either mono input or
TRS stereo input. The pedal ships in mono input
configuration from the factory. Here's how to
change the input configuration:
Remove the back cover of your pedal. On the left
side of the circuit board, you'll see a jumper that
can be set in two positions. Place the jumper on the
left 2 pins for TRS stereo input. Place the jumper
on the right 2 pins for mono input.
Stereo input Mono input
Press and hold to engage the
Circular Repeats feature.
Release to return the controls
to their previous settings.
In order to use the TRS stereo input,
you'll need a TRS stereo input adapter
like the one shown below.
RIGHT 1/4" INPUT
RING
RING
TIP
SLEEVE TIP
pg 10
®