Horizon Fitness Excel 207 User Manual page 6

A SS E MBLY STEP 3
( Excel 307 & Excel 407)
PERIMETER BARS
SCREWS (M)
REAR STABILIZER COVER
NOTE: Excel 207 SKIP THIS STEP
A) Open HARDWARE BAG FOR STEP 3.
B) Attach the PERIMETER BARS using 4 BOLTS (L).
C) Attach REAR STABILIZER COVER using 2 SCREWS (M).
D) Attach FRONT STABILIZER COVERS using 2 SCREWS (M) for each side.
HARDWARE BAG FOR STEP 3 CONTENTS :
10
SCREWS (M)
FRONT STABILIZER COVER
BOLTS (N)
BOLTS (L)
Excel 307 & Excel 407 ONLY
BOLT(L) SCREW(M)
40 mm 10 mm
Qty:2 Qty:6
BOLT(N)
50 mm
Qty:2
A SSEMBLY STEP 4
CONSOLE MAST
NOTE: There is NO hardware bag for this step. All hardware is pre-installed.
A) Remove PRE-ATTACHED BOLT & WASHERS from CONSOLE MAST.
B) Slide LOWER HANDLEBARS onto CONSOLE MAST and attach by re-inserting PRE-ATTACHED BOLT & WASHERS.
C) Slide UPPER HANDLEBARS onto LOWER HANDLEBARS and align NOTCH with TAB making sure handlebars are
joined together completely. Secure UPPER HANDLEBARS to LOWER HANDLEBARS using PRE-ATTACHED SET
SCREWS.
After handlebars are assembled they will rotate freely – be cautious. Until the
WARNING
machine is fully assembled, do not grab the handlebars for support.
UPPER HANDLEBAR
NOTCH
PRE-ATTACHED
TAB SET SCREWS
PRE-ATTACHED
BOLT & WASHER
LOWER HANDLEBAR
11