Table of Contents
Advertisement
Your fully assembled cleaner should look like this:
Figure 8
Swivel Head
III. Installation
The automatic reg u l ator va l ve automat i c a l ly adjusts to ch a n ges in
the amount of water fl ow to provide the cleaner with the powe r
n e c e s s a ry to ensure proper cleaning perfo rm a n c e.
1. Turn the pool pump off.
2. Close the main drain and all suction lines, except
the line from the skimmer to which your cleaner
will be connected.
3. Remove the skimmer basket.
4. Screw the threaded compression adapter into the
vacuum connection in the bottom of the skimmer.
See Figure 9.
tape around the threads of the adapter to ensure
easy removal.
bottom of the skimmer is not threaded, use a 2 inch
hose cone adapter. See Figure 9. The hose cone is
not included with your cleaner, but can be purchased
from your Pentair Pool Products Dealer.)
5. Press the automatic regulator valve into the threaded
compression adapter. See Figure 10. The end of the
va l ve that is marked " at t a ch hose this end" must point up.
6 . Place the cleaner into the pool and allow it to sink to the
fl o o r. Continue to feed the hose down into the pool until
it is completely filled with water and purged of air.
7. Insert the hose through the skimmer opening, and
push it onto the automatic regulator valve.
See Figure 10.
Female End of a
Male/Female Hose
Section
NOTE: Use two wraps of Teflon
(If the vacuum connection in the
NOTE: The hose length illustrated is not
representative of actual size. You will need
to use more sections than shown.
Hose Weight
(If needed)
6'
Figure 9
Automatic
Regulator Valve
Threaded
Adapter
2'' Hose Cone
(not included)
Figure 10
Top of Skimmer
Hose
through
Skimmer
Opening
Automatic
Regulator
Valve
Threaded
Compression
Adapter
(or 2'' Hose Cone)
Female /Female Section
to be added last
Attach Hose This End
Screw (or press) into
bottom of skimmer
Advertisement
Table of Contents
