Summary of Contents for Pentair Pool Products Prowler 720
Page 1
Prowler 720 ® Robotic Inground Pool Cleaners Installation User's Guide IMPORTANT SAFETY INSTRUCTIONS READ AND FOLLOW ALL INSTRUCTIONS SAVE THESE INSTRUCTIONS...
Page 2
Customer Service If you have questions about ordering Pentair Water Pool and Spa (”Pentair”) replacement parts, and pool products, please use the following contact information: Customer Service (8 A.M. to 5 P.M. — Eastern and Pacific Times) Phone: (800) 831-7133 Fax: (800) 284-4151 Technical Support Sanford, North Carolina (8 A.M.
Call (800) 831-7133 for additional free copies of these instructions. Consumer Information and Safety The Prowler 720 and 730 pool cleaners are designed and manufactured to provide many years of safe and reliable ® service when installed, operated and maintained according to the information in this manual. Throughout the manual, safety warnings and cautions are identified by the “...
Pentair Water Pool and Spa, Inc. is not responsible for any pattern removal, abrasions or markings on vinyl liners. Prowler 720 and 730 Installation and User’s Guide...
About Your Pool and Prowler 720 and 730 There are a multitude of factors that contribute to the life of your pool. The Prowler 720 and 730 robotic pool cleaners are very passive products that will have no impact on pool life.
Powerful, efficient, and smart! The Prowler 720 and 730 features the patented Aqua Smart System. This intelligent program enables the cleaner to fully cover and efficiently clean any standard residential swimming pool in approximately one hour minutes for larger residential pools).
Cleans any size, shape and type of standard residential pool in only one hour. • The intelligent program enables the cleaner to fully cover and efficiently clean any standard residential swimming pool in approximately one hour (90 minutes for larger residential pools). Prowler 720 and 730 Installation and User’s Guide...
Section 2 Installation The following general information describes how to install the Prowler 720 and 730 robotic pool cleaners. Carefully read the following so that you are fully aware of all the capabilities and features this Prowler cleaner has to offer.
Operating the Prowler 720 and 730 Cleaners, cont’d. 1. Place the power supply, (transformer), at least ten feet / three meters from the pool as shown in Figure 2. The transformer will supply low voltage to the cleaner. 2. Uncoil the cable as shown in Figure 3.
(Remember to keep the Power Supply at least 10 feet away from the pool.) indicator light will turn off signaling that the machine has stopped running. Prowler 720 and 730 Installation and User’s Guide...
CAUTION — Be sure to always keep your Pentair pool cleaner properly stored anywhere between 50° to 104° Fahrenheit, (10° to 40° Celsius). This will keep the motors, plastics and seals protected. Failure to comply will result in loss of warranty. Prowler 720 and 730 Installation and User’s Guide...
4. Push the cover downwards into the 2 slots (Step 4). 5. Push the top of the cover towards the battery until it snaps into place (Step 5). 6. Put the screw back into place. Figure 13. Prowler 720 and 730 Installation and User’s Guide...
5. Re-install the bag on the support bars with the label in the center of one of the long sides of the bottom lid, see Step 6. 6. Re-install the bottom lid assembly onto the body. Push down on it until all (4) locking tabs snap properly into place. Lock Tabs Label Figure 14. Prowler 720 and 730 Installation and User’s Guide...
4. Place the new PVA brush onto the hexagonal tube and replace the end hub. Wheel Tube 5. Re-install the wheel tube in place and reattach the side plate by screwing back- in the four screws. Brush End Hub Prowler 720 and 730 Installation and User’s Guide...
When the Pool Season is over, you should thoroughly clean the Filter Bag. Make sure that there is no water in the Prowler cleaner. Completely untangle and then properly coil the Floating Cable. Your Prowler cleaner and Power Supply should be stored in a dry, protected area away from freezing temperatures. Prowler 720 and 730 Installation and User’s Guide...
BODY ASSY. - INCLUDES P/N P12105 SHRINK TUBE - 1 METER P12123 P12124 SHRINK TUBE - 1 METER P12125 BUTT CONNECTOR SWIVEL SOCKET Used on both of the Prowler 720 & 730 models. Prowler 720 and 730 Installation and User’s Guide...
BODY ASSY. - INCLUDES P/N P12115 SHRINK TUBE 1 METER P12123 SWIVEL P12137 REMOTE CONTROL P12138 AXLE FOR WHEEL TUBE ASSY. SOCKET Used on both of the Prowler 720 & 730 models. SAVE THESE INSTRUCTIONS. Prowler 720 and 730 Installation and User’s Guide...
Page 22
Notes Prowler 720 and 730 Installation and User’s Guide...
Page 23
Notes Prowler 720 and 730 Installation and User’s Guide...