Pool Preparation; Assembly; Ii. Assembly - Pentair Pool Products Kreepy Kadet Owner's Manual

I. Preparation of Your Pool
Before assembling and installing your cleaner, your pool should be clean and algae-free so as not to
inhibit the cleaner's traction. If necessary, make the following preparations before proceeding:
1. Chemically balance the pool water.
2. Brush pool and let the debris settle.
3. Hand vacuum thoroughly.
4. Clean filter and pump strainer basket.
II. Assembly and Installation
R e m ove the cleaner and all of its parts from the box and ch e ck to make sure that all components we re
i n cl u d e d. Refer to Fi g u re 1.
Components Check List
11. Kreepy Kadet
12. Weighted Bumper Strap
13. Step Deflector
14. Float
15. Hose Weight
16. Valve Cap
17. Automatic Regulator Valve
18. Threaded Compression Adapter
19. Guide Wheel
10. Pleated Seal
11. Eyeball Diverter with Outer Ring
12. Skirt
1 3 . Hose – 32 ft. total length
(not show n )
Step 1. Attach The Seal
To install the seal locate the words "This Side
Up" and face them towards the main body, slip
the seal over the foot pad – (fl at side dow n
t owa rds pool floor) – and pull ge n t ly until it
s e ats itself on the other side in its gro ove as
illustrated in Figure 2. Seal must be installed
flat side down, pleated side up. Once in place,
the seal should rotate and turn freely.
The seal is not reversible. The raised pleats on
the Pleated seal must face upward. The flat side
of the seal should face down to rest against the
pool surface.
Figure 1
3.
4.
5.
9.
6.
7.
8.
Figure 2
The fl at side of seal faces down to rest on the pool's surfa c e.
1.
Serial Number
11.
10.
Main
Body
Pleats of
Pleated Seal
2.
12.
Pleated Seal
in Groove
Foot Pad