Installing The Power Board - Toshiba NB300 Maintenance Manual

4 Replacement Procedures
3. Press down the finger that protrudes to the power board on its left side. Slide the power
board left to remove it.
Note: Be careful not to damage the Power Board when connecting it with the cable. Make
sure the card is seated in the correct position.

Installing the Power Board

Install the power board according to the following procedures.
1. Seat the power board in the correct position on the logic upper assembly.
2. Slide the power board to the end of the track until the latch clicks into place.
3. Place the power board cable into the connector on the motherboard.
4. Secure the power board cable with adhesive tape.
NB300 Maintenance Manual
Error! Style not defined. Error! Style not defined.
Figure 4.24 Removing the Power Board
4-28