About This Product; Detatching And Replacing The Front Grille (X-Hm82, X-Hm82D, X-Hm72 And X-Hm72D Only); Checking What's In The Box; Loading The Batteries - Pioneer X-HM82-S Operating Instructions Manual

Before you start

About this product

X-HM82, X-HM82D, X-HM72 or X-HM72D
X-HM82, X-HM82D, X-HM72 or X-HM72D Network CD
Receiver System consists of the main unit and speaker
system.
5 V 2.1 A PHONES AUDIO IN
ON TIMER
XC-HM82 or XC-HM82D
XC-HM82 or XC-HM82D Network CD Receiver consists of the
main unit.
5 V 2.1 A PHONES AUDIO IN
ON TIMER
Detatching and replacing the front grille (X-
HM82, X-HM82D, X-HM72 and X-HM72D only)
The front grille of this speaker system is removable. Proceed
as follows:
1
Grab the bottom of the grille, and
gently pull it toward you to remove
the bottom portion.
2
Next, grab the top part of the grille
and gently pull it toward you to
remove the top portion.
3
To install the grille, align the projections
on the speaker with the receptacles on
the top and at the base of the grille and
push them into place.

Checking what's in the box

Please check that you've received the following supplied
accessories:
• Remote control
• Power cord
• AAA size IEC R03 dry cell batteries (to confirm system
operation) x 2
• AM loop antenna (X-HM82, XC-HM82 and X-HM72 only)
• FM wire antenna (X-HM82, XC-HM82 and X-HM72 only)
• DAB/FM wire antenna (X-HM82D, XC-HM82D and X-
HM72D only)
• WLAN antenna x 2
• Speaker x 2 (X-HM82, X-HM82D, X-HM72 and X-HM72D
only)
• Speaker wires x 2 (X-HM82, X-HM82D, X-HM72 and X-
HM72D only)
• Non skid pad x 8 (X-HM82 and X-HM82D only)
• iPhone/iPad stand
• Warranty card
• Quick Start Guide
• These operating instructions (CD-ROM)

Loading the batteries

The batteries included with the receiver have been provided to
allow you check product operation and may not last long. We
recommend using alkaline batteries that have a longer life.
WARNING
• Do not use or store batteries in direct sunlight or other
excessively hot place, such as inside a car or near a heater.
This can cause batteries to leak, overheat, explode or catch
fire. It can also reduce the life or performance of batteries.
CAUTION
• Incorrect use of batteries may result in such hazards as
leakage and bursting. Observe the following precautions:
Never use new and old batteries together.
-
Insert the plus and minus sides of the batteries properly
-
according to the marks in the battery case.
Batteries with the same shape may have different
-
voltages. Do not use different batteries together.
- When disposing of used batteries, please comply with
governmental regulations or environmental public
institution's rules that apply in your country/area.
- When inserting the batteries, make sure not to damage
the springs on the battery's  terminals. This can cause
batteries to leak or over heat.

Operating range of remote control

The remote has a range of about 7 m at an angle of about 30°
from the remote sensor.
30°
30°
7 m
Keep in mind the following when using the remote control:
• Make sure that there are no obstacles between the remote
and the remote sensor on the receiver.
• Remote operation may become unreliable if strong sunlight
or fluorescent light is shining on the receiver's remote
sensor.
• Remote controllers for different devices can interfere with
each other. Avoid using remotes for other equipment
located close to this receiver.
• Replace the batteries when you notice a fall off in the
operating range of the remote.
5