PANEL DESCRIPTION
Connections
1- IN
1/4" mono jack connections for signal input.
FLEX-DISTO require 1/4" stereo jack connections for Link
Mode operations.
2- OUT
1/4" mono jack connections for signal output.
FLEX-DISTO require 1/4" stereo jack connections for Link
Mode operations.
3- Power
The FLEX-DISTO require 9V DC xxx mA. By using the
power supply, you can play without being concerned about
how much battery power you have left.
Use only the specified AC adaptor (9V linear regulated)
If there is a battery in the unit while an AC adaptor is
To change the battery you need to unscrew the
being used, the FW-DOD will switch over to battery-
powered operation should the line voltage be
interrupted.
four screws placed on the bottom panel