Important Notes - FlexWaves FW-DOD User Manual

 Inserting a connecting plug into the INPUT jack will automatically switch the unit on.
 The use of an AC adaptor is recommended as the unit's power consumption is relatively high.
 The Flex-DISTO requires 9V 200mA. Use a regulated power supply with the right polarity to prevent malfunctions or noise
related problems.
 To prevent malfunction and/or damage to speakers or other devices, always turn down the volume, and
turn off the power on all devices before making any connections.
 Some connection cables contain resistors. When connection cables with resistors are used, the sound level may be
extremely low, or impossible to hear. For information on cable specifications, contact the manufacturer of the cable.
 If there are batteries in the unit while an AC adaptor is being used, normal operation will continue should
the line voltage be interrupted (power blackout or power cord disconnection).
 Once the connections have been completed, turn on power to your various devices in the order
specified. By turning on devices in the wrong order, you risk causing malfunction and/or damage to
speakers and other devices.
 When powering up: Turn on the power to your guitar amp last.
 When powering down: Turn off the power to your guitar amp first.
 If the power is turned off inappropriately while saving a preset/bank, saved data may be lost.
 Link Mode features are available only connecting the Flex Waves pedals in chain using Stereo Audio cable. Please use the
patch cables provided by Flex Waves or similar ones.
 It can happens that turning on the unit or inserting the jack in the input port, the Flex Disto changes its state in Link Mode (L-
on display). Press the mode switch to change the Mode.
 As with all true-bypass effects, switching is not perfectly silent. There may be some popping sound when you switch. A
popping sound is not an indication that the effect is defective or not working. It is the small drawback to the great
improvement in tone that takes place when poorly buffered effects are taken out of the loop (thus made true-bypass).

IMPORTANT NOTES