Wipers And Washers - Honda 2016 Accord Owner's Manual

Wipers and Washers

■
Windshield Wiper/Washer
Pull to
use
washer.
MIST
OFF
INT * : Low speed with
intermittent
AUTO * : Wiper speed varies
automatically
LO: Low speed wipe
HI: High speed wipe
*1:Models with the smart entry system have an ENGINE START/STOP button instead of an
ignition switch.
* Not available on all models
uuOperating the Switches Around the Steering WheeluWipers and Washers
The windshield wipers and washers can be
used when the ignition switch is in ON
■
MIST
The wipers run at high speed until you release
the lever.
■
Wiper switch (OFF, INT * , LO, HI)
Change the wiper switch setting according to
the amount of rain.
■
AUTO *
2 Automatic Intermittent Wipers
■
Adjusting wiper operation
Turn the adjustment ring to adjust the wiper delay.
Lower speed, fewer sweeps
Higher speed, more sweeps
■
Washer
Sprays while you pull the lever toward you.
When you release the lever for more than one
second, the spray stops, the wipers sweep two or
three more times to clear the windshield, then stop.
I n f o r ma t i o n P r o v i d e d b y :
1Wipers and Washers
NOTICE
Do not use the wipers when the windshield is dry.
*1 .
( w
The windshield will get scratched, or the rubber
blades will get damaged.
NOTICE
In cold weather, the blades may freeze to the
windshield, becoming stuck.
Operating the wipers in this condition may damage
them. Use the defroster to warm the windshield,
then turn the wipers on.
Models without automatic intermittent wipers
If the vehicle speeds up while the wipers are
* P. 152
operating intermittently, the length of the wipe
interval shortens.
When the vehicle starts moving, the wipers make a
single sweep.
When the vehicle speeds up, the wiper operation's
shortest delay setting ( ) and the LO setting become
the same.
All models
Turn the washers off if no washer fluid comes out.
The pump may get damaged.
The wiper motor may stop motor operation
temporarily to prevent an overload. Wiper operation
will return to normal within a few minutes, once the
circuit has returned to normal.
Continued 151