Wipers And Washers - Honda Civic 2019 Manual

Hide thumbs Also See for Civic 2019:
Table of Contents

Advertisement

Wipers and Washers

Windshield Wiper/Washer
Pull to
use
washer.
Intermittent Time
Adjustment Ring
*
MIST
OFF
INT
*2
/AUTO
*3
LO: Low speed wipe
HI: High speed wipe
*1: Models with the smart entry system have an ENGINE START/STOP button instead of an
ignition switch.
*2: Models with manual intermittent operation
*3: Models with automatic intermittent operation
* Not available on all models
uuOperating the Switches Around the Steering WheeluWipers and Washers
The windshield wipers and washers can be
used when the ignition switch is in ON
MIST
The wipers run at high speed until you release
the lever.
Wiper switch (OFF, INT
*2
/AUTO
HI)
Move the lever up or down to change the
wiper settings.
Adjusting wiper operation
Turn the adjustment ring to adjust the wiper
operation.
Lower speed, fewer sweeps
Higher speed, more sweeps
Washer
Sprays while you pull the lever toward you.
When you release the lever for more than one
second, the spray stops, the wipers sweep two
or three more times to clear the windshield,
then stop.
1Wipers and Washers
NOTICE
Do not use the wipers when the windshield is dry.
(
w
*1
.
The windshield will get scratched, or the rubber
blades will get damaged.
NOTICE
In cold weather, the blades may freeze to the
windshield.
*3
, LO,
Operating the wipers in this condition may damage
the wipers. Use the defroster to warm the
windshield, then turn the wipers on.
Models with intermittent time adjustment ring
If the vehicle speeds up while the wipers are
*
operating intermittently, the length of the wipe
interval shortens.
When the vehicle speeds up, the wiper operation's
shortest delay setting ( ) and the LO setting become
the same.
All models
Turn the washers off if no washer fluid comes out.
The pump may get damaged.
The wiper motor may stop motor operation
temporarily to prevent an overload. Wiper operation
will return to normal within a few minutes, once the
circuit has returned to normal.
If the wiper stops operating due to any obstacle such as
the build-up of snow, park the vehicle in a safe place.
Rotate the wiper switch to OFF, and turn the ignition
switch to ACCESSORY
remove the obstacle.
Continued
(
q
or LOCK
(
0
*1
, then
173

Advertisement

Table of Contents
loading

Table of Contents