Honda 2016 Accord Owner's Manual page 343

uuHomeLink® Universal Transceiver
■
Training a Button
1. Position the remote transmitter you wish to link 1 to 3 inches (3 - 8 cm) from the
HomeLink button you want to program.
2.
Press and release the desired HomeLink button. Hold the button on the remote
transmitter. Does the HomeLink indicator (LED) change from slowly blinking to
constantly on or rapidly blinking? The process should take less than 60 seconds.
YES
3.
Press and hold the
programmed HomeLink
button for about a sec.
Does the device (garage
door opener) work?
YES NO
4. Press and hold the HomeLink button again.
Training
HomeLink LED is
Complete
constantly on.
5.
Press and hold the HomeLink
button again.
The remote-controlled device
should operate.
Training Complete
342
* uTraining HomeLink
NO
Press and release the HomeLink button. Press
and release the button on the remote every 2
secs.
YES
Does the HomeLink indicator (LED) change from
slowly blinking to constantly on or rapidly
blinking? The process should take less than 60
seconds.
HomeLink indicator rapidly blinks.
A.
The remote has a rolling code. Press the
"learn" button on the remote-controlled
device (e.g. garage door opener).
B.
Within 30 secs, press and hold the
programmed HomeLink button for 2 secs.
1Training HomeLink
Retraining a Button
If you want to retrain a programmed button for a
new device, you do not have to erase all button
memory. You can replace the existing memory code
using this procedure:
1. Press and hold the desired HomeLink button
NO
Standard transmitter
Indicator remains on
for about 25 secs.
2. Quickly release the HomeLink button and follow
Erasing Codes
To erase all the codes, press and hold the two outside
buttons until the HomeLink indicator begins to blink
(about 10 to 20 secs). You should erase all codes
before selling the vehicle.
If you have any problems, see the device's
instructions, visit www.homelink.com, or call
HomeLink at (800) 355-3515.
HomeLink® is a registered trademark of Gentex
Corporation.
I n f o r ma t i o n P r o v i d e d b y :
until the HomeLink indicator begins to blink.
Rolling code transmitter
Indicator remains on for
about 25 secs.
steps 1 - 3 under "Training a Button." You do not
need to press and release the HomeLink button
again in step 2.