Panasonic CF-M34 Reference Manual page 19

Standby/Hibernation Functions
Windows 98 Windows NT
When [Hibernation] is not displayed in [Power Switch] of the [Power] menu in the
Setup Utility, the hibernation specific partition on the hard disk is not available. Rein-
stall the OS to create the partition by using the Product Recovery CD-ROM.
Windows 98
When both [Turn off monitor] (in [Control Panel] - [Power Management] - [Power
Schemes]) and [Screen Saver] (in [Control Panel] - [Display] - [Screen Saver]) are
set, there are cases operations cannot resume in a normal manner from the standby
or hibernation mode.
When the screensaver setting is active, do not enter the standby or hibernation mode
while the [MS-DOS Prompt] is being displayed. There are cases operations cannot
resume in a normal manner.
When the computer resumes from the standby/hibernation mode when MS-DOS
is running, the screen may become completely black. In such cases, press
Alt + Tab .
If you are using a PC card, note that some cards may cease to function if the standby
or hibernation function is used several times. When this occurs, immediately shut
down Windows without using the standby or hibernation function.
Windows NT
Confirm that Phoenix APM 2.0 for Windows NT
time to be normally displayed with the hibernation function. (If [APM 2.0 for NT] is
displayed in [Control Panel], this means that the program is installed.)
Do not enter the hibernation mode before logging on. The computer will no longer
generate a sound and will not function properly.
Manually set the computer in the hibernation mode when not using the computer,
since there are cases the hibernation timeout may not work properly.
®
is installed, in order for the date and
19