Resuming Operation - Panasonic CF-M34 Reference Manual

Standby/Hibernation Functions
Slide the power switch

Resuming Operation

Windows NT
If the security indicator (
This password has been set in the Setup Utility and is not a Windows NT password.
Windows 98 Windows 2000
When the computer enters either the standby or hibernation mode by the closing of the
LCD panel, it will resume when the LCD panel is opened. If the computer does not
resume when the LCD panel is opened, press the power switch.
CAUTION
After the display returns, the computer needs a short period of time to reinitialize.
This takes about 30 seconds. Do not shut down or restart Windows, or enter
either the standby or hibernation mode again during this time, as this may subse-
quently cause Windows to operate abnormally.
Do not install or remove peripherals while your computer is in the standby or
hibernation mode; abnormal operation may result.
When operation resumes, serial devices such as a mouse, modem or PC Cards
may not function properly. In such cases, you will need to restart your computer
or reinitialize the individual devices.
Avoid the following until the power is completely turned off when turning off the
computer by using the standby or hibernation functions, or resuming operation
from the standby or hibernation.
• Touch the keyboard (excluding password input), touch pad, or power switch.
• Connect or disconnect the AC adaptor.
• Close the display.
Windows 98 Windows 2000
Even when a password has been set in the Setup Utility,
when the computer resumes from the standby or hibernation mode.
(If you want to use the security function when using the standby or hibernation
mode, use the Windows password as the following.
Select [Start] - [Settings] - [Control Panel] - [Power Management]* - [Advanced],
then add the check mark for [Prompt for password when computer goes off
standby].)
Windows 2000
* 3 : [Power Options]
) is displayed, your password has been set.
17
does not appear